ここから本文です
TWO:By caresses, by tyranny, by stratagems, Trzia opened prison doors, obtained pardons, delivered [311] victims from the guillotine. Immense numbers of people were saved by her exertions. Several times her influence dissolved the Revolutionary Committee; under her reign people began to breathe freely at Bordeaux, and the Terror for a time seemed nearly at an end.Next day the destinies of France were in the hands of Calonne.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:These children, of whom she was the elder by a year, were the only ones who survived of the four born to their parents, and were devotedly fond of each other; the remembrance of their happy childhood together in the rambling old chateau and the great garden with its terrace over the Loire always remained vividly impressed upon the mind of Flicit.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:The French army had overrun Belgium, everyone was flying towards Holland; the road was encumbered with vehicles of all kinds. Old post-chaises, great family coaches, open carts, were filled with fugitives; many went down the Rhine in boats.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Mme. de Boisgeloup, however, received the children with the greatest kindness, her two boys were companions for the young Cabarrus, and as for Trzia, she loved and treated her like a daughter. They lived in the rue dAnjou, and when the following year her father arrived at Paris and bought a h?tel in the place des Victoires she still spent less of her time with him than with her.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.